Liquid ceramic wax Ceramic Wax FullCarX 500 ml
Ceramic Wax is a liquid ceramic spray wax from the FCX GOLD range, to be sprayed onto a clean and dry bodywork. It provides hydrophobic protection and an intense shine, without holograms or residues, in a 500 ml bottle.
Liquid ceramic wax Ceramic Wax FullCarX: shine and hydrophobic protection
FullCarX Ceramic Wax is a liquid ceramic spray wax intended for motorists who want a show finish without going through the application of a complete ceramic coating. Sprayed onto a clean, dry bodywork, it lays down a hydrophobic film that makes water bead and repels dust, while providing an intense, transparent shine to the paint.
A nanowax with 100% active matter
Ceramic Wax belongs to the FCX GOLD range, FullCarX’s premium line, built on three principles highlighted by the brand: top-quality raw materials, a very high concentration, and 100% active matter. This concentration explains the consistency of the film deposited, even in a thin layer, as well as the yield of the 500 ml bottle.
What the wax brings to the bodywork
- Intense and transparent shine that enhances the original shade without masking it.
- Long-lasting hydrophobic protection that repels water and dust between washes.
- Hologram-free finish, without marks or residue, thanks to the product’s instant evaporation.
- Quick application, area by area, by hand and without a polishing machine.
Two complementary uses
Ceramic Wax is used on its own, as a protective sealant after a careful wash: it is the most direct solution to protect a vehicle that has not received any treatment. It also serves as a maintenance product on top of a protection already in place, whether it is a ceramic coating, a wax, or a hydrophobic coating. It then boosts the beading effect and revives the shine without attacking the existing layer.
What protection duration to expect
FullCarX announces hydrophobic protection lasting from 1 to 2 months. This duration varies depending on the vehicle’s use, where it is parked, and the frequency of washes: a car parked outside and cleaned every week will require reapplication more frequently than a vehicle stored in a garage. A quick pass of Ceramic Wax after each wash is enough to maintain the level of shine and water beading.
Instructions for use of the liquid ceramic wax Ceramic Wax FullCarX
Ceramic Wax is applied by hand, area by area, on bodywork that has already been washed. The product does not clean: the quality of the result depends entirely on the preparation of the surface before spraying.
Prepare the bodywork
- Wash the vehicle and rinse it thoroughly, for example after a pre-wash with Snow Foam FullCarX active foam shampoo.
- Dry the bodywork completely: it must be clean and perfectly dry.
- Work in the shade, on cool bodywork, to prevent the product from drying too quickly.
Apply the ceramic wax
- Spray Ceramic Wax onto a limited area, half a hood or a door, for example.
- Spread the product immediately with a clean microfiber cloth, crossing the passes.
- Wipe with a second dry microfiber cloth to reveal the shine.
- Repeat area by area until the entire bodywork is covered.
Maintain an existing protection
- Wash the vehicle normally, without a stripping product.
- Apply Ceramic Wax in a thin layer over the ceramic treatment, wax, or hydrophobic coating already applied.
- Repeat the operation as soon as the beading effect weakens.
Good to know
Always use clean microfibers: a microfiber loaded with dust can mark the clear coat. Change sides of the cloth as soon as it becomes saturated and keep the finishing microfiber strictly dry. Close the bottle after each use and store it at room temperature.