Sealant Activate Shine and Seal Chemical Guys 473 ml
The Activate Shine and Seal spray sealant from Chemical Guys combines carnauba wax and synthetic polymers thanks to Reactive Fusion Technology. This 473 ml bottle applies hydrophobic protection and a glossy finish in just a few minutes.
Activate Shine and Seal Sealant Chemical Guys: shine and protection in one pass
Activate Shine and Seal is Chemical Guys’ spray sealant, designed for motorists who want to protect their paint without spending half a day on it. It is sprayed directly onto a clean bodywork and lays down, in a single pass, a protective layer that makes it shine and repels water. The 473 ml bottle is suitable both for routine maintenance after washing and for a finishing touch after decontamination.
A formula that combines wax and sealant
Chemical Guys designed this product around its Reactive Fusion Technology, which brings together three families of ingredients in the same bottle.
- Carnauba wax for depth and warmth of the reflection
- Gloss enhancers for an immediate wet look
- Synthetic sealants for durability against external aggressions
This combination pursues two objectives stated by the brand: reduce application time and extend the duration of protection.
A glossy and hydrophobic finish
Once buffed, the film left by Activate Shine and Seal makes the surface slick to the touch and causes water to bead. Contaminants and dirt adhere less to paint sealed this way, which makes subsequent washes easier. The product is suitable for light shades as well as dark shades.
When to use it
- As maintenance protection, after each full wash
- As a quick finishing touch after using a clay bar
- To restore gloss between two heavier protections
The format offered
AGM Vision offers Activate Shine and Seal in a 473 ml spray bottle, the reference capacity in the Chemical Guys catalog for this sealant. The brand also offers it in 118 ml for occasional use or for a first trial.
Instructions for use of the Activate Shine and Seal sealant Chemical Guys
Chemical Guys sums up the use of Activate Shine and Seal in three steps: shake, spray, wipe. In practice, a few method precautions make the difference between a clean finish and a haze of streaks on the paint.
Routine application after washing
- Wash the car and dry it completely, in the shade and on cool bodywork.
- Shake the bottle vigorously to mix and activate the solution.
- Spray on one panel at a time, or directly onto a foam applicator.
- Spread in a thin, even layer, without overloading the product.
- Buff with a clean microfiber, then go over again with a dry side.
Finishing after decontamination or polishing
- Finish using the clay bar or polish over the entire vehicle.
- Degrease the bodywork to remove polishing residues.
- Apply the sealant panel by panel using the same method.
- Check the result in raking light before moving on to the next panel.
Precautions
- Never apply in direct sunlight or on a hot surface.
- Change microfiber as soon as it becomes saturated, otherwise you may leave streaks.
- Wipe off immediately any overspray on unpainted plastics and seals.
- Keep the bottle closed, protected from freezing, and out of reach of children.