Black chenille microfiber wash mitt Chemical Guys
The black Chemical Guys chenille wash mitt is made of 70/30 microfiber and traps dirt at the core of its strands in order to protect the clear coat. Its double-stitched cuff ensures a good grip, and it is machine washable.
Chemical Guys black chenille microfiber wash mitt: a scratch-free wash
The Chemical Guys black chenille microfiber wash mitt is a car wash mitt designed for manual cleaning of the bodywork. Its long chenille strands trap dirt deep within the weave and keep it away from the clear coat, where a smooth sponge makes it slide over the paint. It is aimed at motorists who wash their vehicle themselves and who want to limit micro-scratches.
A 70/30 microfiber designed for bodywork
Chemical Guys uses here a 70/30 microfiber blend, a soft composition that glides over the clear coat without attacking it. The chenille strands hold a large amount of water and foam, which maintains a lubricating film between the mitt and the paint throughout the wash.
What the mitt brings to washing
- Deep dirt capture : particles remain trapped between the strands instead of being dragged over the bodywork.
- Large foam reserve : the mitt stays loaded with shampoo from one panel to the next.
- Double-stitched cuff : the mitt holds well in the hand and withstands repeated washes.
- Easy maintenance : it goes in the washing machine and regains its original suppleness.
Which surfaces to use it on
The mitt is suitable for paint, glass, and exterior plastics, on a vehicle already rinsed and covered in foam. Reserve it for the bodywork: the dirtiest areas, such as wheel arches, rocker panels, and rims, require a dedicated accessory, otherwise you risk bringing sand and brake dust back onto panels that are already clean.
A consumable to keep an eye on
A wash mitt remains a wear item. As soon as the strands harden, remain loaded with residue, or the weave loosens, replace it: a tired mitt no longer retains dirt and becomes the primary cause of micro-scratches during washing.
Instructions for use of the black chenille microfiber wash mitt Chemical Guys
The result of a hand wash depends as much on the method as on the mitt itself. Here’s how to get the most out of the Chemical Guys chenille mitt and keep it for a long time.
Wash the bodywork
- Rinse the vehicle thoroughly to remove most of the dust and sand.
- Apply a car shampoo, for example Citrus Wash and Gloss, and let the foam work.
- Dip the mitt into the bucket of solution without wringing it out, then lay it flat on a panel, in straight lines, from top to bottom.
- Rinse the mitt in a second bucket of clean water after each panel to release the trapped dirt.
- Rinse the car, then dry it with a microfiber drying towel to avoid water spots.
Maintain the mitt after use
- Rinse the mitt with clean water until the water runs clear.
- Machine-wash it in hot water with Chemical Guys Microfiber Wash detergent.
- Tumble-dry it on low heat, then store it away from dust.
Precautions
Do not use fabric softener or dryer sheets: Chemical Guys specifies that they clog the microfibers and make them non-absorbent. Also avoid washing the mitt with linty laundry. If it falls on the ground during washing, set it aside and run it through the washing machine again before reusing it.