LED Bulb R5W/R10W BA15S 24V – Heavy-duty vehicle

The R5W/R10W BA15S LED 24V bulb is used for position lights, clearance lights and interior lighting on heavy goods vehicles in 24 volts. Its BA15S bayonet base (same base as the P21W, but reduced power) ensures reliable fastening despite vibrations. The R5W and R10W share the same BA15S base as the P21W, but with lower power, suitable for position lights. The LED version offers instant lighting (no warm-up time), a 20 times longer lifespan than that of a conventional bulb and reduced consumption by 80 %. At AGM Vision, our R5W/R10W BA15S LED 24V bulbs are tested in real conditions on heavy goods vehicles.

To choose the right R5W/R10W BA15S LED 24V, first check the original base of your current bulb: it must match the BA15S bayonet base format (same base as the P21W, but reduced power). Then, check the required color: white for reverse and position lights, orange for turn signals, red for brake lights. The brightness in lumens must be sufficient to ensure regulatory visibility. Also check the dimensions: some LEDs are longer than the original bulb. AGM Vision specifies compatibility and dimensions on each product sheet for an error-free choice.

Yes, replacement is very simple and requires no special tools. Remove the original bulb by turning it a quarter turn (bayonet base) or by pulling it out (wedge base). Insert the 24V LED in the same direction. For bayonet bases, align the lugs with the slots in the holder. Turn on the lights to check operation. If the LED does not light up, turn it 180° (polarity reversal). If an error message appears on the dashboard, add a 24V anti-error module in parallel. The operation takes less than 5 minutes per bulb.

It depends on the electrical system of your heavy-duty vehicle. If the truck is equipped with a CAN bus or burnt-out bulb detection, the LED’s low power consumption can trigger an error light or rapid flashing. In this case, a 24V load resistor (or anti-error module) connected in parallel solves the problem. Older trucks, without onboard electronics, generally don’t need it. Test first without a resistor and add one only if necessary. AGM Vision offers specific 24V resistors suited to each type of base.

A quality R5W/R10W BA15S LED 24V offers a lifespan of 25,000 to 50,000 hours, compared with 1,000 to 2,000 hours for a traditional filament bulb. For a truck running 10 hours a day, this represents more than 6 years without replacement. LEDs withstand vibrations better thanks to the absence of a fragile filament, a crucial advantage on heavy goods vehicles. In addition, the instantaneous switching on of LEDs improves safety: LED brake lights come on 0.2 seconds faster than traditional bulbs, providing extra reaction time for the vehicles following.