T10 W5W 24V LED Bulb – Truck and heavy-duty vehicle

The T10 W5W LED 24V bulb is used for parking lights, position lights, cab interior lighting and indicator lights on 24-volt heavy goods vehicles. Its wedge T10 (W2.1x9.5d) base ensures reliable fastening despite vibrations. The T10 W5W format is universal and is found on virtually all heavy goods vehicles for secondary lighting. The LED version offers instant switch-on (no warm-up time), a 20 times longer lifespan than a conventional bulb, and reduced consumption by 80 %. At AGM Vision, our T10 W5W LED 24V bulbs are tested under real conditions on heavy goods vehicles.

To choose the right T10 W5W LED 24V, first check the original base of your current bulb: it must match the wedge T10 (W2.1x9.5d) format. Then, check the required color: white for reverse and position lights, orange for turn signals, red for brake lights. The brightness in lumens must be sufficient to ensure regulatory visibility. Also check the dimensions: some LEDs are longer than the original bulb. AGM Vision specifies compatibility and dimensions on each product sheet for an error-free choice.

Yes, replacement is very simple and requires no special tools. Remove the original bulb by turning it a quarter turn (bayonet base) or by pulling it out (wedge base). Insert the 24V LED in the same direction. For bayonet bases, align the lugs with the slots in the holder. Turn on the lights to check operation. If the LED does not light up, turn it 180° (polarity reversal). If an error message appears on the dashboard, add a 24V anti-error module in parallel. The operation takes less than 5 minutes per bulb.

It depends on the electrical system of your heavy vehicle. If the truck is equipped with a CAN bus or a burnt-out bulb detection, the low power consumption of the LED can trigger an error light or rapid flashing. In this case, a 24V load resistor (or anti-error module) connected in parallel solves the problem. Older trucks, without onboard electronics, generally do not need it. Test first without a resistor and add one only if necessary. AGM Vision offers specific 24V resistors suited to each type of base.

A quality T10 W5W LED 24V offers a lifespan of 25,000 to 50,000 hours, compared with 1,000 to 2,000 hours for a classic filament bulb. For a truck driving 10 hours per day, this represents more than 6 years without replacement. LEDs withstand vibrations better thanks to the absence of a fragile filament, a crucial advantage on heavy goods vehicles. In addition, the instant-on of LEDs improves safety: LED brake lights come on 0.2 seconds faster than classic bulbs, providing extra reaction time for the vehicles following.