LED bulb replacement ring

The replacement ring (or adapter) is an aluminum part that attaches to the LED bulb to adapt its base to the headlight housing. The H7 LED ring, our best-seller, makes it possible to securely fasten H7 LED kits in optics requiring a specific ring.

Some vehicles use a specific locking system with a retaining ring that does not fit the LED format. The replacement ring solves this problem by providing an adapter that fits into the original housing and accommodates the LED. Check the type of ring on your vehicle before purchase.

The H7 ring fits the majority of vehicles using a rotary ring retaining system. If your vehicle uses a spring clip instead, consult our range of retaining rods. If in doubt, contact our customer service indicating the make and model of your vehicle.

Yes, the H1 replacement ring is specially designed to adapt H1 LED kits to optics whose fastening system differs from the standard. It ensures a firm hold and precise alignment of the light beam.

Installation is simple: insert the ring into the headlight housing in place of the old one, lock it by rotating or clipping it, then insert the LED bulb into the ring. The ring stays in place permanently, which makes subsequent bulb changes easier.

No, our rings are precision-machined to position the LED bulb exactly at the same focal point as the original halogen. The beam thus retains its correct geometry (sharp cutoff in low beam) and the existing headlight adjustment remains valid.