Cordless electric foam cannon FullCarX 1.5 L
The FullCarX electric foam cannon generates a dense foam at the press of a button, without a pressure washer or compressor. Its 1.5 L tank makes it possible to cover the complete prewash of a medium-sized vehicle.
FullCarX cordless electric foam cannon: pre-wash without high pressure
The FullCarX electric foam cannon is a self-contained, battery-powered foam sprayer designed for the pre-wash stage. It produces dense foam at the press of a button, without a pressure washer or connection to a compressor. It is aimed at both private individuals and detailers who want to loosen dirt before hand washing, including far from a pressurized water source.
A pre-wash without a pressure washer
The foam coats the bodywork and gives the shampoo time to act on dust, insects, and road deposits. This contact time limits direct rubbing of the microfiber on a surface that is still dirty, the main cause of micro-scratches during washing.
Device features
- 1.5 L tank, sufficient for the pre-wash of a medium-sized vehicle
- Built-in rechargeable battery and USB Type-C charging cable included
- Cordless operation, without a compressor or supply hose
- Weight of about 1 kg, usable with one hand
- Side decompression button to release pressure after use
Compatible with active foam shampoos
The device is filled with a pre-wash shampoo diluted in water. FullCarX recommends a 1:5 dilution, i.e., 100 ml of shampoo for 0.5 L of water. It works with the active foams in the range, such as Snow Foam FullCarX.
In which situations to use it
- Pre-washing the bodywork before a two-bucket hand wash
- Applying foam to wheels and wheel arches
- Outdoor washing, in a condominium or on the go, without a pressurized water supply
- Targeted treatment of the dirtiest areas, such as rocker panels and bumpers
Instructions for use of the FullCarX cordless electric foam cannon
The FullCarX electric foam cannon can be set up in just a few minutes. The quality of the foam obtained mainly depends on two parameters: the shampoo dilution and the pressure build-up before spraying.
Prepare and fill the tank
- Charge the battery using the supplied USB Type-C cable.
- Pour the shampoo into the tank, following a 1:5 dilution, i.e. 100 ml of product for 0.5 L of water.
- Top up with water without exceeding the 1.5 L capacity, then close the tank.
Apply the foam to the vehicle
- Hold the button for a few seconds: the pressure builds up and the flow becomes steady.
- Spray from bottom to top to cover the bodywork with an even layer.
- Leave it to act for the time indicated by the shampoo manufacturer, without letting the foam dry.
- Rinse thoroughly, then follow up with the two-bucket hand wash.
Precautions
- After use, hold the blue side button for a few seconds to release the pressure built up in the tank.
- Rinse the tank with clean water to prevent the shampoo from drying in the circuit.
- Do not apply the foam to hot bodywork or bodywork exposed to direct sunlight.
- Store the device with the tank emptied and depressurized, battery recharged.